Verex Monitor ISM Especificações descarregar pdf (Página 30)

26 MONITOR ISM™/AFx™ IP Connectivity Guide 22-9058 v2.1

3.5.4 SIP Receiver Software: Configuration Settings

When you start up the IP receiver software, click on the configuration tab at the bottom. Each

panel IP-connection to be 'polled' is associated with one row on the screen. The top half of the

screen contains settings for the automation software that must be set appropriately, and the

row for each IP connection must be set up as well. Refer to the descriptions below while

making your selections.

Top half of the screen (setting for the automation software):

• Active: (  ) = SIP monitoring is turned on

(this selection is required).

• UDP Port

: The port number used on this PC

for SIP Communications. Typically 24833.

• Serial Port

: The PC's serial port used to

communicate with the automation software.

• Prefix

: Leave as “S011[#”. This is the prefix

to be added to alarm messages.

Reference:

“S” = SIA,

“01” = receiver number 1,

“1” = line card number 1,

“[#” = standard SIA prefix.

• Line Trouble

: SIA code to be generated if

the SIP connection fails. Typically "LT"

(the

same as for a modem connection; can be

changed to other valid SIA value)

• Heartbeat

: A standard signal that goes to

the automation software to show it that the

receiver is active. If the heartbeat signal

fails, the automation software should inform

the operator right away.

WARNING:

double check this setting to

make sure it is: 1011(11 spaces

) @ (4

spaces) /020. The proper number of spaces

between characters is very important.

• Baud

: The speed used for communications

with the automation software. Normally

1200.

• Separator

: Leave as N (new event SIA block).

• Line Restore

: SIA code to be generated

when SIP communications restores.

Typically "LR"

(the same as for a modem

connection; can be changed to other valid

SIA value).

--------------------

• Mode

: The communications format used

with the automation software. Normally,

7,E,1 (7 data bits, even parity, 1 stop bit).

• Suffix

: Leave as “]\020”.

• Substitution

: “UX5” SIA code that will be

generated if a substitution of panel

equipment is detected.

• Ticks

: How often a heartbeat signal is sent

to the automation software. Typically every

30 seconds.

--------------------

• Timeout

: The maximum time this program

will wait for an acknowledge signal from the

automation software. Typically, 2000 milli-

seconds.

• ACK

: Leave as “/006”. Standard ack signal.

• Sub’ Restore

: “UX6” SIA code that is

always generated immediately after a

substitution detection.

--------------------

• Retries

: The maximum number of times this

software will attempt to send a message to

the automation software. Typically 3.

• NAK

: Leave as “/021”. Standard nak signal.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Comentários a estes Manuais

Sem comentários

Verex Monitor ISM Especificações Página 30

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Verex Monitor ISM