Verex Monitor ISM Especificações descarregar pdf (Página 14)

10 MONITOR ISM™/AFx™ IP Connectivity Guide

22-9058 v2.1

Identification

New Name E.g. location of IP board (30 -alpha/numeric-characters maximum).

New Password

Enter a maximum 8-alpha/numeric-character password that will restrict access to the

config screens in the future. Be sure to mark this password down in a secure place as it will be requested

each time the IP Module configurations are accessed.

IP Address should be the one assigned for the module at its final destination.

Net Mask

If it is not needed, enter “0.0.0.0”.

Gateway

If it is not needed, enter “0.0.0.0”.

Security (check boxes)

Disable Telnet Check this box if denying access to the config programming by Telnet.

Disable Password

Check this box if a password to access the configs is not required.

Disable Remote Configuration

Check this box to disable remotely connecting to this IP board’s

configuration. This will not disable using “Discovery Mode”.

Disable File Download

Check this box to deny firmware upgrades to this IP board.

• Press the “Send To” button on the top tool bar.

• The activity bar at the bottom of the config screen will change from Online to “Configuration download

complete”.

• The IP Host board has now been programmed. Press the Disconnect button and return to the

Connection screen to view the new settings instead of e.g. question marks.

The unit can be pinged again with a reply like the following:

Other IP Configuration Program Tool Bar Buttons

Follow the on screen instructions after pressing a button.

• Abort

Cancel “Connect” attempt if it appears an IP Interface Module is not responding.

• Disconnect

on line communications between the config program and an IP board.

• Upgrade

IP Interface Module’s firmware version to a newer one.

• Force

If the IP board whose firmware is being upgraded with a previous version (for what ever

reason) replies after the upgrade attempt that the version is not current, this button can be pushed to

force the upgrade.

• Save

- a current config to a template file.

• Load

- a saved template file to program an IP board.

• Defaults

Return configured screens back to their defaults EXCEPT the IP address, Subnet Mask and

Default Gateway settings will remain the same.

• Help

Display IP Config Program version number.

Connecting to a Programmed IP Board

• To connect to an IP Interface Module that has already been configured, click on the “Connect

remotely…” selection in the Connection screen.

• Enter the board’s IP address and applicable password and then press the “Connect” button.

Debug Tab

Is for Manufacturer’s Use Only.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comentários a estes Manuais

Sem comentários

Verex Monitor ISM Especificações Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Verex Monitor ISM